Description:
Brand New set of silver coated headers that are designed for small block Chrysler 231-330 Hemi V8 engines in Model A and up chassis. This is same as the DD4 header, but with the wider 14¾" flange bolt spacing. The DD5 drops straight down, and the collector is tight to the oil pan. The DD5 will fit almost any application that does not a cross member behind the motor mounts, and the bolt pattern should measure 14¾" center to center (see image below). Check out our store for the other coating options.
Comes with all hardware necessary for installation.
NOTE: For cylinder heads with 14-3/8" spacing, order #DD4
SPECIFICATIONS:
Engine : Chrysler 231-330 Hemi Small Block V8
Primary Tube Diameter : 1½"
Collector Diameter : 2½"
Weight : 15 LBS / 6.80 KGS
FEATURES:
- 16-Gauge Primary and Collector Tube Thickness
- 3/8" Thick Flange
- Patented Flange Design Requires NO Gaskets
- Tightest Fitting Header Available Anywhere!
- Made in the USA
INCLUDES:
- Header Bolt Set
- Angle Collector Reducer Set
NOTES:
- The Patented Leak-Free Design that Sanderson Headers offer you is the only leak-free flange design on the market ... Do Not Attempt To Use Flange Gaskets! The raised flange on the Sanderson Headers will buckle the gasket during tightening and actually cause a leak!
- Sanderson Headers are NOT emissions legal on pollution-controlled motor vehicles. It is the purchaser's responsibility to verify local regulations for compliance.
- Wrapping your Sanderson Headers with ANY thermal tape voids your header warranty. The best thermal protection for your headers is our Aluminized Ceramic Coating that is available for every Sanderson Header.
WARRANTY:
Limited 5-Year Warranty
DIMENSIONS:
When sitting in driver's seat and engine in front of you, the LEFT header would be the Driver's Side on LH drive vehicles; coincidently, means the RIGHT header is on the passenger side. See the detail image that describes engine sides.
Please Note: It could take up to 10-14 days for delivery of item. If needed sooner please contact our office at (319) 988-4045
DD6-SEC
|